Material Testing & Documentation
Material selection matters for furniture projects. The summaries below describe specific material samples and supplier documentation provided for review. They do not certify Vintara Design, every material option, or a finished furniture item. Please confirm the applicable material specification and project requirements before ordering.
Foam: U.S. Smolder-Resistance Test
A white foam sample, with a measured density of 25.3 kg/m³, met California Technical Bulletin 117-2013 (R2019), Section 3, for resilient filling materials. All three test specimens passed. Report date: November 29, 2022. This is a sample-level smolder-resistance result, not a claim that furniture is fireproof.
Foam: U.K. Ignitability Test
A polyurethane slab-foam sample, approximately 36.9 kg/m³ and 76 mm thick, passed Schedule 1, Part I of the U.K. Furniture and Furnishings (Fire) (Safety) Regulations 1988, with the amendments identified in the report. Testing was based on BS 5852: Part 2: 1982 using ignition source 5. Report date: April 23, 2024. Results concern the tested material combination under the stated test conditions, not the full fire hazard of a finished product.
Conventional Foam: Emissions & Substance Testing
A conventional polyurethane foam sample passed the listed emissions and substance tests under Section 6 of the CertiPUR-US® Technical Guidelines for Slabstock Foam (March 2025). Report date: April 10, 2026. Listed tests covered emissions, metals of concern, tributyltin, phthalates, TDA/MDA and the specified polybrominated flame-retardant additives.
At 72 hours, the reported TVOC result was 0.192 mg/m³ against a criterion of less than 0.5 mg/m³; formaldehyde was below 0.001 mg/m³ against a criterion of less than 0.015 mg/m³. These are laboratory results for the submitted foam sample, not indoor-air measurements of a completed room or furniture item.
A separate supplier certificate is available for the conventional foam family. Its scope is the supplier's specified flexible polyurethane foam family, not Vintara Design or finished furniture. The supplied document does not establish that every foam option offered on this website is covered.
Water-Based Adhesive: Selected Chemical Tests
A water-based adhesive sample was tested with reference to HJ 2541-2016, using the specified requirements for rubber-type water-based construction adhesives. Report date: September 5, 2022. The listed results for free formaldehyde, benzene, toluene/ethylbenzene/xylene, halogenated hydrocarbons and total volatile organic compounds met the stated requirements and were below the respective detection limits.
“Not detected” means below the test method's detection limit, not absolute absence. These results apply only to the submitted adhesive sample and are not a finished-furniture environmental certification.
Textile Documentation: Historical Record
The supplied OEKO-TEX® STANDARD 100 textile certificate covered specified woven, knitted and coated fabrics in Product Class II, Annex 4, for products with direct skin contact. It is a historical record only and is not presented as current certification or proof that any particular fabric currently offered is covered.
For Your Project
When discussing a project, please tell us your destination market and required material or test standard so that the relevant specification and available documentation can be checked. Test results apply only to the tested samples, dates and conditions. A material test or supplier certificate does not automatically establish compliance of every finished furniture configuration.
